Enables GPIB Control of Tektronix Instruments through the USB Port of Tektronix Instruments Compliant with USBTMC-USB488 Standards
GPIB Primary Address is Assignable through the Host Tektronix Instrument
Powered by USB Host or Optional External Power Supply
LED Indicators Provide Power, Adapter Status, and USB Status
Can be used in Rackmount Instrument Configurations
Digital Design
Research and Development
Manufacturing Test
ATE Environments
Service and Support
Education
The TEK-USB-488 Adapter enables communication between a GPIB bus controller, and the USB port of a USBTMC-USB488 compliant Tektronix instrument (for example, the DPO4000 Series Oscilloscopes).
Compatible with Tektronix instruments providing USBTMC-USB488 compliant USB ports supporting the protocol and USB extensions required for setting the adapter’s GPIB primary address. For USBTMC-USB488 instruments not supporting these USB extensions and protocol, the GPIB address defaults to address “1” and cannot be changed. Each adapter controls one instrument and does not support use of USB hubs.
Physical Connection - GPIB interface connector provided on adapter.
Compliance - IEEE 488.2 compliant.
Bulk Data Rate - Specification not available at this time.
Front-panel Indicators - Power Applied, Adapter Status, and USB Status.
Temperature
Operating - 0 °C to +50 °C.
Nonoperating - -20 °C to +60 °C.
Humidity
Operating - (High) 40 °C to 50 °C, 10% to 60% relative humidity; (Low) 0 °C to 40 °C, 10% to 90% relative humidity.
Nonoperating - (High) 40 °C to 60 °C, 5% to 60% relative humidity; (Low) 0 °C to 40 °C, 5% to 90% relative humidity.
Altitude
Operating - Up to 3,000 m (10,000 ft.).
Nonoperating - Up to 15,240 m (50,000 ft.).
Emissions Compliance - EN 55011, Class A.
EMC Compliance - EN61326, Class A.
Compliance Labeling -
C-Tick (Australia / New Zealand).
CE (European Union).
WEEE (European Union).
Source Power - Provided by USB host or orderable external power supply.
Power Consumption - Regulated at 5 VDC at <500 mA.
Physical Characteristics